Serpent 600238 Rear Antiroll Bar 2.5mm - Handling Tuning Part  [SER600238]

Serpent SER600238 Antiroll bar Rear 2.5mm
Price:
£4.05
Brand:
Serpent
Model:
SER600238
Condition:
Brand New
Write a review

Refine Rear Handling with Serpent 600238 2.5mm

The Serpent 600238 rear antiroll bar is intended to tighten rear roll characteristics and improve overall stability in RC vehicles. Choosing the 2.5mm option helps make cornering more predictable across a range of surfaces.

How the 2.5mm Size Affects Balance

A 2.5mm bar increases rear roll resistance enough to limit excessive lean while still allowing the suspension to react to bumps. This trade off tends to produce cleaner corner exits and steadier lap times for experienced tuners.

Installation Notes and Compatibility Advice

Compatible with many rear link assemblies, the Serpent 600238 fits with common mounting arrangements and replaces softer bars easily. Check linkage geometry and tighten all fixings after installation to ensure reliable performance.

Does this bar require setup changes elsewhere on the car?

You may need to tweak rear spring rate, ride height or toe to reestablish balance after fitting the 2.5mm bar. Make one change at a time and test to find the best combination.

What signs indicate the bar is a good match for my setup?

Improved mid corner stability, reduced body roll and more consistent lap times are good indicators. If the rear becomes too lively, consider a slightly softer rear bar or adjust front settings.

How often should I inspect the antiroll bar and links?

Inspect the bar, link pins and mounting hardware regularly, especially after hard runs. Replace any worn items and ensure pivots remain free to move for consistent handling.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved