Serpent 600533 Centre Front Driveshaft 811-S Upgrade [SER600533]

Serpent SER600533 Driveshaft Center Front 811-S

Price:

£12.03

Brand:

Serpent

Model:

SER600533

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Centre front driveshaft solution for the Serpent 811-S

The Serpent 600533 Centre Front Driveshaft supports smoother torque delivery on the Serpent 811-S chassis, helping to reduce driveline lash and deliver a more predictable throttle response. It is intended as a dependable replacement or upgrade for competitive setups.

Key points about the Serpent 600533

Compatibility: Specifically produced to suit the Serpent 811-S layout for correct fitment and alignment.
Reliability: Made to stand up to frequent use and routine racing demands.
Drive feel: Aims to enhance power transfer to the front end, aiding acceleration and control in tight sections.

How do I check the driveshaft after a crash?

Inspect for straightness and any distortion, check spline engagement and ensure fasteners are intact. Replace if you find bends or significant wear.

Should I change any setup when fitting this part?

Major setup changes are not usually required, but verify drivetrain alignment and test on track to confirm desired handling. Small diff or toe tweaks may help fine tune balance.

Does the Serpent 600533 need special tools to fit?

Standard RC tools are normally sufficient. Use the correct screwdrivers and check torque values; avoid overtightening to prevent damage.

How do I tell if this is the right part for my car?

Confirm your chassis is the 811-S and compare mounting points and spline interfaces. The part is intended for that model; mismatched components can cause fitment issues.