Serpent 600661 7075 T6 Rear Uprights for Cobra 2.0  [SER600661]

Serpent SER600661 Upright Left + Right 811 2.0 Aluminium
Price:
£38.75
Brand:
Serpent
Model:
SER600661
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

High precision rear uprights for Cobra 2.0

The Serpent 600661 aluminium rear uprights are crafted for the Cobra 2.0 buggy to deliver a race-ready balance of stiffness and lightness. Using 7075 T6 alloy ensures robust performance under repeated track stress.

Accurate fit and protective finish

Manufactured to provide a tight bearing fit, these uprights reduce unwanted movement and improve rear tracking. Installation is simplified via pre-threaded holes, and the grey anodised coat helps shield the aluminium from wear.

Vehicle match and upgrade suggestions

These uprights are intended for direct fitment to the Serpent Cobra 2.0 chassis. For a coordinated upgrade, use them alongside the Upright L+R 811 2.0 (#600634) and reassess suspension geometry after fitting to fine tune handling.

Will the Serpent 600661 uprights work with aftermarket bearings?

They accept standard small-buggy bearing sizes, so compatible aftermarket bearings should fit. Check bearing outer diameter before pressing in to ensure a snug seat.

How durable is the grey anodised surface?

The anodised finish resists light scratching and corrosion from dirt and moisture, though heavy impacts can still mark the surface. Regular cleaning will extend its life.

Can I run these uprights for off-road bashing as well as racing?

They are robust enough for spirited off-road use, but like any alloy part they can be damaged by extreme crashes. Inspect parts after hard impacts and replace if bent or cracked.

Do I need special tools to fit these uprights?

No specialised tools are required beyond basic RC hand tools and a bearing press or driver. Use correct size drivers to avoid stripping hardware.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved