Serpent 600946 Front Driveshaft Centre Block for SRX8E - Precision Component  [SER600946]

Serpent SER600946 Driveshaft Center Front Block Layout SRX8E
Price:
£10.76
Brand:
Serpent
Model:
SER600946
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Drive stability with the front centre block

The Serpent 600946 front driveshaft centre block is intended to improve front axle consistency on SRX8E cars, aiding the Cobra SRX8-E Pro in maintaining predictable handling lines. It is useful for both repair work and setup upgrades.

Advantages for serious hobbyists

This block supports better driveshaft alignment which often translates to steadier steering inputs and reduced front-end wander during sustained laps. It is aimed at those tuning for repeatable track performance.

Model alignment and service advice

The part is produced with fitment for Cobra SRX8-E Pro and SER600021 series in mind, allowing direct replacement where compatible. Fit as part of scheduled maintenance or when refining front-end geometry.

No chassis surgery is usually needed if your car follows the Cobra SRX8-E Pro specification. Confirm matching mounting points before committing to fitment.
Yes, it is intended to deliver consistent front geometry which is helpful for lap consistency in club and regional events.
When installing on a modified car, verify driveshaft clearances and recheck steering geometry. Small adjustments to linkages may be needed to restore intended handling.
After fitting, rotate the drivetrain and check for smooth operation and no binding. Inspect screw torque and ensure the block sits flush with its mounts.
The 600946 is specified alongside the SER600021 references for the Cobra SRX8-E Pro series, so it integrates where those parts are used together.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved