Serpent 601093 SRX8T Rear Front Suspension Bracket - Performance Kit  [SER601093]

Serpent SER601093 Suspension bracket Rear Front SRX8T
Price:
£22.73
Brand:
Serpent
Model:
SER601093
Condition:
Brand New
Write a review

Fine-Tune Your SRX8T with Serpent 601093

If you are refining a race setup, the Serpent 601093 suspension bracket is a practical upgrade. Intended for SRX8T use, this rear front bracket strengthens the suspension mount area and supports steadier on-track behaviour.

Engineered for Stability

The bracket is produced to provide reliable alignment and enhanced durability under frequent running. Its intent is to support predictable handling, making it suitable for both practice sessions and competitive outings. Drivers may notice improved response entering and exiting turns.

Compatibility and Fit

Made to suit the Cobra SRX8 Truggy GP (SER600059) and compatible with the Cobra SRX8 Buggy Series, the bracket fits the SRX8T chassis layout. Installation uses common RC tools and is designed to be straightforward for hobbyists.

Can I swap this between left and right sides?

The bracket is symmetric in its mounting design for the SRX8T, but follow the installation guide for correct orientation and torque settings.

Will it fit if I run non-standard shock positions?

If your shock or arm geometry differs from the SRX8T reference layout, verify clearance before fitting; the part is optimised for standard SRX8T setups.

Is professional fitting required?

No, a competent hobbyist with routine RC tools can fit the bracket; take care to check fastener security and alignment after the first runs.

How should I check for correct installation?

After fitting, cycle the suspension through its travel, inspect for contact or binding, and re-check screw tightness after initial running.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved