Serpent 601112 2.6mm Rear Antiroll Bar for SRX8T - Race Setup  [SER601112]

Serpent SER601112 Antiroll bar Rear 2.6mm SRX8T
Price:
£4.14
Brand:
Serpent
Model:
SER601112
Condition:
Brand New
Write a review

Control Rear Roll with a Stiffer Swaybar

To refine handling on the Cobra SRX8 Truggy GP, the Serpent 601112 Rear Antiroll Bar is a focused upgrade. The 2.6mm rear bar trims unwanted roll and helps the SRX8T respond more predictably when pushing hard through corners.

Measured Stiffness for Track Use

The 2.6mm dimension offers a measured increase in rear stiffness that improves lateral stability without making the chassis harsh. The part is made to withstand frequent race use and setup changes.

Compatibility Notes and Fit

Designed for the Cobra SRX8 Buggy Series, this antiroll bar is a direct-fit upgrade in most cases and allows quick trackside swaps to evaluate different rear roll settings.

Will the Serpent 601112 change understeer on my car?

Increasing rear roll stiffness with the Serpent 601112 can reduce rear squat and may shift balance toward understeer or neutral depending on front setup. Test in small steps to find the right balance.

What maintenance should I do on the antiroll bar?

Regularly check for wear at the mounting points and inspect the bar for bends. Clean mounting areas and replace any worn pivot hardware to keep the roll rate consistent.

Can I tune the rear roll progressively with this bar?

Yes, try swapping between thinner and thicker bars or changing end link positions to progressively adjust rear roll until the SRX8T matches your driving style.

Is any special hardware needed to install the 601112?

Installation normally uses existing rear antiroll bar mounts and common hardware. Keep spare pins and clips handy if you plan frequent swaps at the track.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved