Serpent 803200 Precision 16mm Rod Set with Ball Joints  [SER803200]

Serpent SER803200 Rod Set 16mm / Ball Joints (2)
Price:
£8.96
Brand:
Serpent
Model:
SER803200
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Accurate Suspension Tweaks for Serpent 720

Improve cornering precision on your Serpent 720 with the Serpent 803200 Rod Set, intended for controlled suspension adjustments. The set contains ultra-short track rods and composite 16mm ball joints, allowing use of the shortest upper track rod pivot hole on the optional GTP suspension support plate (SP-803182).

Square Nut for Rapid Tuning

The Serpent 803200 Rod Set features a square nut on each rod so you can change lengths without removing the track rods, simplifying adjustments between runs. The reduced-length composite ball joints offer reliable articulation for more consistent steering input.

Is this product a direct swap onto other models?

This rod set is tailored to the Serpent 720 layout. It may fit other models in some cases, but you should verify pivot spacing and lengths before fitting.

Any tips for initial setup after fitting?

After fitting, start with small, equal adjustments on both sides using the square nut and test on a familiar track. Note changes and refine incrementally for best results.

How should I check for wear in the rods and joints?

Regularly inspect joints for play and rods for any thread or bend damage. Replace components showing wear to retain consistent steering and suspension behaviour.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved