Serpent 804107 Low Friction Kevlar Drive Belt Set for 733  [SER804107]

Serpent SER804107 Belt set 733 Low Friction (3)
Price:
£20.41
Brand:
Serpent
Model:
SER804107
Condition:
Brand New
Write a review

Reliable Kevlar Drive Belts for 733 Chassis

Modelers aiming for dependable drivetrain behaviour will value the Serpent 804107 belt set, built to limit friction and extend service life. Specifically for the 733 chassis, the kit includes three Kevlar-reinforced belts designed to retain tension and resist wear. The selection comprises a 5mm wide 186T rear belt, a 4mm wide 195T front belt, and a 378T side belt, all specified to support efficient power delivery.

Specifications

  • Material: Kevlar Reinforced
  • Rear Belt: 5mm wide, 186T
  • Front Belt: 4mm wide, 195T
  • Side Belt: 378T
  • Compatibility: Serpent 733 Chassis

A dependable replacement set for racers and club drivers who need low friction, hard wearing belts to keep lap times consistent.

What maintenance should I perform on these belts?

Inspect belts for fraying and check tension before each meeting; clean off grit and re-tension after heavy runs to avoid accelerated wear.

Are these belts suitable for high power setups?

The Kevlar reinforcement improves strength under load, making these belts a good match for higher power motors when paired with correct tensioning and pulley alignment.

How do I check belt alignment?

Rotate the system slowly and watch belt tracking on pulleys; adjust motor or idler positions until belts sit centrally across pulley faces without rubbing or wandering.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved