Serpent 804337 RC Servo Saver Shaft Outer for 748 Chassis Performance  [SER804337]

Serpent SER804337 Servo Saver Shaft Outer 748
Price:
£8.65
Brand:
Serpent
Model:
SER804337
Condition:
Brand New
Write a review

Improve Steering Accuracy with Serpent 804337

The Serpent 804337 Servo Saver Shaft Outer is made to cut steering slack on the 748 chassis, giving drivers a more precise steering feel. It is a solid part for setup refinement and regular maintenance.

Built to Tight Tolerances

Manufactured to precise dimensions, the Serpent 804337 reduces play where it matters, helping the car track cleaner through corners. The part is suited to both club racing and hobby use.

Usage and Care

Swap this shaft into the Serpent 748 chassis for immediate improvement in steering response. Check the unit periodically and replace if you spot any wear or looseness to keep handling consistent.

Is this compatible with stock 748 parts?

Yes, it is produced to match the 748 chassis mounting. Always check mating components for wear and make minor adjustments to steering geometry if needed.

What tools are recommended for fitting?

Use small hex drivers, needle nose pliers and a torque feeler where available. Tighten fasteners evenly and confirm there's no binding in the steering travel.

How often should I inspect this part?

Inspect after crashes and during routine service intervals. Replace the shaft if it shows play, scoring or deformation to maintain predictable steering.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved