Serpent 804365 Alloy Servo Lever for 1/10 RC  [SER804365]

Serpent SER804365 Servo Lever Steering Aluminium 24T 748
Price:
£20.31
Brand:
Serpent
Model:
SER804365
Condition:
Brand New
Write a review

About the Serpent 804365 Servo Lever

The Serpent 804365 Aluminium Servo Lever is designed to enhance steering accuracy in 1/10 scale RC models by replacing flexible or worn servo horns. Its machined aluminium build focuses on consistent control and resilience under regular use.

Performance and Durability

Crafted from aluminium, this lever gives a rigid connection between servo and linkage while remaining compact. The 24T spline is widely used, helping to ensure a secure fit and reduce slop in steering actuation.

Installation and Use

Built for 1/10 scale vehicles, the Serpent 804365 fits into most common setups and is intended as a direct swap for standard servo arms. Check spline compatibility and clearances before fitting to avoid interference with surrounding components.

Can this replace plastic servo horns on my car?

Yes, the Serpent 804365 is a common upgrade to replace plastic horns. The aluminium construction reduces flex and is less prone to wear, improving steering feel.

Will it add significant weight to the car?

The lever adds minimal weight compared with plastic alternatives while offering greater stiffness. The trade-off is generally beneficial for steering precision without affecting handling noticeably.

Do I need to change my servo settings after fitting?

Most users keep their existing end points and trim, but you may want to re-centre and check travel to ensure the new lever does not alter steering limits or cause binding.

Is any finishing required on the part?

A quick check for machining burrs and a light clean is all that is normally needed. Some users choose to anodise for cosmetic reasons or extra surface protection.

Can this be used on vintage or custom servos?

It can work if the servo has a matching 24T spline and physical clearance. For non-standard or older servos, verify spline count and shaft diameter before fitting.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved