Serpent SER804411 Rear Bearingblock Pair for S750 Natrix  [SER804411]

Serpent SER804411 Bearingblock up Rear Left + Right S750
Price:
£47.06
Brand:
Serpent
Model:
SER804411
Condition:
Brand New
Write a review

Serpent SER804411 Rear Bearingblock for S750

The Serpent SER804411 bearingblock secures the rear left and right positions on the Natrix 750 chassis, helping to keep wheel geometry steady. It is aimed at hobbyists who want to restore rear alignment and control.

Model fit and simple installation

Made to align with the Natrix 750 rear mount points, this bearingblock installs with basic RC tools and minimal fuss. After fitting, check the rear suspension to confirm correct alignment.

Performance and maintenance notes

Keeping the rear mounts in good order reduces play and contributes to a predictable rear end. Inspect the bearingblock during routine maintenance and replace at the first sign of distortion.

Is this the same part used in race setups?

This is the OEM style bearingblock for the Natrix 750 rear mounts. Racers may use the same part for consistency, but any tuning changes should be confirmed by setup checks.

What is the recommended procedure after fitting?

After fitting, run through alignment checks for toe and camber, and perform a short test run to ensure the rear feel is correct before a full session.

Can I service the bearingblock in situ?

Minor inspections can be done without full disassembly, but if play is detected remove the unit for a full check and replace bearings or the block as needed.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved