Serpent 804468 Front Upper Bearing Block Natrix 750 EVO - Circuit Focus [SER804468]

Serpent SER804468 Bearingblock Front up L S750 EVO

Price:

£18.14

Brand:

Serpent

Model:

SER804468

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Secure Front Suspension Geometry for the Natrix 750 EVO

The Serpent 804468 Front Upper Bearing Block is crafted to support accurate front suspension geometry on the Natrix 750 EVO 200mm GP chassis. By stabilising the upper bearing location it reduces play in the steering assembly and helps the car track truer through fast sections. The component is produced to withstand the demands of frequent racing.

Feature Overview of the Serpent 804468

Compatibility: Specifically matched to the Serpent Natrix 750 EVO for correct positioning.
Material: Tough construction chosen for endurance under race stresses.
Functionality: Keeps suspension components aligned to enhance steering precision.
Durability: Built to cope with the repetitive loads of circuit running.

Is this compatible with aftermarket uprights?

Compatibility depends on the upright design; many aftermarket parts match stock mounting points but verify dimensions before buying.

Should bearings be replaced when fitting this block?

It is good practice to fit fresh bearings when upgrading to ensure smooth operation and eliminate any variables affecting alignment.

Will it survive contact during close racing?

The block is made to tolerate impacts typical of close racing, but severe hits can still damage any component so inspect after heavy contact.

Any setup tips after installing?

After fitting, recheck toe and camber, tighten all fasteners to spec, and run a few low speed laps to confirm handling is as expected.