Serpent 903583 Carbon Rear Shock Extension Bracket Set - Competition Carbon Brackets  [SER903583]

Serpent SER903583 Shock Extension Bracket Rear Carbon (2)
Price:
£11.69
Brand:
Serpent
Model:
SER903583
Condition:
Brand New
Write a review
alt="Serpent SER903583 Shock Extension Bracket Rear Carbon (2)" title="Serpent SER903583 Shock Extension Bracket Rear Carbon (2)"

Refine Your Handling with Serpent 903583 Carbon Brackets

Replace heavier aluminium parts with the Serpent 903583 Carbon Rear Shock Extension Bracket Set to reduce rear-end weight and tighten handling. These carbon fibre brackets keep strength up while trimming unnecessary bulk for more precise steering and stability.

Material Advantages for Racing

Carbon fibre provides a high stiffness-to-weight ratio useful in racing environments where every gram matters. The reduced mass improves transient response and reduces inertia during rapid direction changes.

Scope and Installation

The Serpent 903583 brackets are compatible with many Serpent layouts and common third-party chassis. Fitting is a straightforward swap; check fastener choices and alignment after installation to maintain correct shock geometry.

Measure the mounting hole spacing and compare it with your current brackets. Many users lay the new bracket over the old one to confirm alignment before fitting.
Light cosmetic work is possible but ensure any paint or tape does not interfere with mounting surfaces. Use paints compatible with composite materials and avoid heavy coats that add weight.
Inspect for hairline cracks, check screw torque and washer condition, and verify no movement at pivot points after a few runs.
Slight changes in mass and stiffness can alter damper behaviour; you may need to adjust damping settings or spring rates to regain the expected balance.
Replacement carbon brackets or compatible parts are often available; keep a spare set on hand if you race frequently to minimise downtime.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved