Serpent 903684 Rear Lightweight Bearing Block for S988 - Precision Replacement  [SER903684]

Serpent SER903684 Bearingblock Rear Lightweight (2) S988
Price:
£38.97
Brand:
Serpent
Model:
SER903684
Condition:
Brand New
Write a review

Precision rear bearing block Serpent 903684 for S988

The Serpent 903684 rear lightweight bearing block is an exacting replacement part for the S988 chassis. It aims to shave excess mass while preserving the strength needed for regular competitive use. Tight tolerances and a clean fit make it a straightforward swap into the factory layout.

How lighter blocks affect chassis dynamics

Reducing rotating and unsprung mass can sharpen the S988's turn-in and make the rear suspension settle faster after bumps. The Serpent component is intended to give these handling improvements without sacrificing reliability under race conditions.

Practical tips for installation and care

Keep all parts clean and check bearings for smooth rotation before assembly. Correct alignment and torque settings are important to prevent binding and to maintain long service intervals for the Serpent 903684.

Do I need special tools to fit these bearing blocks?

Standard hobby tools are usually sufficient. Use proper hex drivers and a torque method to avoid over-tightening fasteners during installation.

Will these change my handling dramatically?

Expect more responsive rear behaviour and crisper feedback, but large changes are unlikely. Fine-tuning suspension and toe settings will make the most of the weight reduction.

What maintenance should I perform after fitting?

Inspect the blocks and surrounding hardware after initial running, check bearings for play, and include them in regular service checks to preserve performance.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved