Serpent SER904156 Midshaft Holder Upgrade for Viper 988E  [SER904156]

Serpent SER904156 Midshaft Holder R 988E
Price:
£10.65
Brand:
Serpent
Model:
SER904156
Condition:
Brand New
Write a review

Drivetrain Midshaft Support for Improved Handling

The Serpent SER904156 Midshaft Holder is intended for the Viper 988E EP and supplies a stable seat for the midshaft, limiting play that can impact handling. It aids consistent power delivery during spirited runs.

Matched to the Viper 988E EP Chassis

This holder is dimensioned to work with the Viper 988E EP layout and secures the midshaft to reduce unwanted movement. That stability helps maintain predictable steering and traction through corners.

Installation Recommendations

Install the Serpent SER904156 Midshaft Holder with attention to alignment and torque. After fitting, check for smooth rotation and clearances and make small adjustments if any binding is detected.

Will fitting this change vehicle balance?

The holder itself is a small component and should not noticeably alter balance. Its main effect is to keep the midshaft aligned, which can improve handling consistency rather than change weight distribution.

Can I use threadlocker on the screws?

Using a mild threadlocker on metal screws is common to prevent loosening. Choose a removable grade and avoid excess so fasteners can be serviced when required.

Should I recheck fit after the first run?

Yes. After the initial session, recheck fastener torque and ensure the midshaft rotates freely with no binding. Small adjustments early on prevent issues later.

Is this recommended for both racing and club use?

The holder is suitable for a range of use cases, from track racing to club practice, wherever stable midshaft alignment is desired to maintain consistent drivetrain behaviour.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved