SRB Tail Boom Support HI0302010 for RC Helicopters by Hirobo  [HI0302010]

HIROBO 0302-010 SRB TAIL BOOM HOLDER #0302010
Price:
£4.78
Brand:
Hirobo
Model:
HI0302010
GTIN:
4512895149987
Condition:
Brand New
Write a review

Installation and Alignment Notes

The Hirobo HI0302010 tail boom holder fits SRB-series tail assemblies and serves to secure the tail boom to the airframe. It is intended as a replacement support part for models using the SRB configuration.

Fit this holder when the original shows wear or damage, or as part of scheduled maintenance to restore correct boom positioning. It interfaces with the tail boom and its support points to maintain alignment necessary for correct tail rotor operation.

Key installation tips: confirm the boom is centered in the holder before final tightening, use the appropriate hex driver and matching fasteners, and avoid overtightening to prevent stress on nearby mounts. Proper setup of this holder helps ensure consistent control geometry and stable tail response.

Will replacing the holder change tail control geometry?

If fitted correctly to the same mounting points, the replacement should restore original geometry. Recheck link positions and tracking after installation to confirm control alignment.

Any tips for achieving perfect alignment?

Loosely fit all fasteners first, center the tail boom visually and by hand rotation, then incrementally tighten while rechecking alignment to achieve a true fit without binding.

Should I inspect anything after the first flight?

After initial flights, recheck fastener torque and holder condition for any shifting or loosening. Confirm tail tracking and control response remain consistent and correct as part of routine checks.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved