SRX8 Gen4 GP Compatible Throttle Lever - Serpent 601380 (SER600024)  [SER601380]

Fitment guide for SRX8 throttle arm

The Serpent 601380 servo lever throttle is intended as a replacement component for Serpent SRX8 Gen4 GP (SER600024) kits. It links the servo output spline to the throttle rod, offering a reliable mounting point to control throw and travel.

Installation is straightforward: remove the old lever, place the new arm on the servo spline in the desired neutral position, secure it with the retaining screw, then reconnect and check the throttle linkage moves freely. Verify transmitter center and endpoints prior to dynamic testing.

In setup the lever sets the leverage and geometry of the throttle linkage. Small changes to arm position or length will influence sensitivity and the available travel, so make incremental adjustments and check for any binding at full throw.