SRX8 KPI V2 Steering Pin Set - Serpent 601401  [SER601401]

Keeping SRX8 Steering Geometry Consistent

This Serpent 601401 steeringblock pin set is an RC-scale replacement and tuning accessory designed for the SRX8 platform, following the KPI V2 steering geometry. The set is supplied as a (2+2) pcs configuration to match left and right mounting points, intended for routine maintenance or when swapping steering components during a setup change.

These pins act as the steeringblock pivot and retention hardware, helping to preserve the SRX8 KPI V2 front-end alignment after maintenance or minor impacts. They are designed to maintain the chassis designer's intended geometry rather than to tune steering characteristics substantially.

Fitting is simple for anyone experienced with SRX8 service: remove the steeringblock, swap in the new pins, ensure secure fit and no excessive play, and then confirm steering travel and toe during final setup. Periodic inspection is advised to sustain predictable handling performance.