SRX8 V2 Front/Rear Suspension Bracket Serpent 601385  [SER601385]

SRX8 V2 bracket briefing for tuners

Presented as Serpent model SER601385, this RC suspension bracket is a direct replacement or spare for front and rear mounting positions on SRX8-series cars. It acts as the structural attachment that governs suspension geometry, alignment repeatability, and potential wear under track and club use.

The bracket is supplied to suit SRX8 V2 chassis and is also applicable where SRX8 Gen4 GP parts share the same mounting arrangement. As a chassis interface it connects with uprights, lower arms, and the shock tower; accurate installation and consistent symmetry are necessary to preserve handling balance when replacing brackets.

When setting up the car this bracket will influence roll centre and camber under load, so many tuners use replacement brackets to repair damage, trial geometry tweaks, or ensure secure mounting after long service. Inspect threaded inserts and bore fits post-install to prevent binding that would change suspension behavior.

Compatibility

• SRX8 V2
• SRX8 Gen4 GP (SER600024)

For UK-based racers and workshop builders maintaining SRX8 chassis, SER601385 restores key mounting points and helps keep suspension geometry predictable through tuning and race preparation.