SSR-VI Stabilizer Link Arm Replacement HI0414217 by Hirobo  [HI0414217]

HIROBO 0414-217 SSR-VI STABILZER CONTROL ARM #0414217
Price:
£15.65
Brand:
Hirobo
Model:
HI0414217
GTIN:
4512895129231
Condition:
Brand New
Write a review

Overview of the stabilizer arm

This Hirobo control arm is a replacement component for the SSR-VI stabilizer assembly on RC helicopters. The description concentrates on the arm's purpose in link geometry and tail stabiliser response rather than material claims. It is supplied for situations where restoring correct geometry or replacing worn linkage joints is required.

Specifications

  • Item: Stabilizer Control Arm
  • Material: Not specified
  • Model Number: HI0414217
  • Compatibility: SSR-VI

Install this control arm when resetting or fine tuning SSR-VI stabilizer geometry. Verify correct fitment before installation and re-check linkage angles during setup to achieve consistent tail response.

How can I confirm this is the correct part for my SSR-VI?

Compare the part's mounting points and hole centres with the items on your helicopter. The listing names SSR-VI compatibility but a physical check ensures correct fit.

Will changing this arm affect tail tuning?

Yes. The arm determines linkage geometry that influences tail-centre and micro corrections, so swapping arms can alter stabiliser feel and may require a tuning check.

Is special tooling needed to fit the arm?

No special tools are typically required; use standard hobby screwdrivers and pliers, and replace any worn screws or ball links to ensure a secure assembly.

What final checks should I perform after installation?

With the model powered down, cycle the servos and inspect for any binding or excess play, then set the stabiliser neutral and verify control response on the ground before flight.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved