Steering Linkage Upgrade Compatible with Axial Yeti YT-25005-BK by Jazrider  [YT-25005-BK]

Fitment Guide for Axial Yeti Steering

This aluminum steering linkage is designed specifically for the Axial Yeti chassis and carries the model number YT-25005-BK. It replaces the stock plastic tie rods to create a more rigid link between the servo output and the steering knuckles, helping retain steering geometry during tough sections.

Fitting is similar to the original assembly: remove the factory tie rods, move or replace the rod ends to suit your setup, and secure with the stock hardware. Apply a small amount of threadlocker where metal-on-metal threads meet, and set neutral toe before final tightening. Check and retighten hardware after an initial run to allow for component seating.

Consider compatibility with existing rod ends and steering components when upgrading, and inspect alignment after installation. The stiffer linkage can alter steering characteristics, so confirm steering center and test on tricky terrain to ensure the handling meets expectations.