SVi to Receiver 150mm i-Connector Cable - Futaba FUEBB0153  [FUEBB0153]

SVi-to-receiver i-Connector lead

This Futaba FUEBB0153 lead is intended as an interface cable to join SVi-capable modules to a receiver using an i-Connector plug. The specification of 150mm length and 30 fine strands offers a balance of flexibility and a small profile so the cable fits cleanly inside typical model radio bays.

The cord is suitable when a direct SVi-to-receiver connection is required without extra adapters. Its stranded make-up allows for neat routing around servos and electronics, and the moderate length is ideal for compact and mid-size models where tidy wiring is preferred.

To fit, insert the i-Connector into the SVi output on compatible Futaba modules then plug the other end into the selected receiver channel. Route the cable clear of thick motor wires and secure it with minimal ties to prevent interference with moving parts. The lead is designed to keep signal paths short and wiring orderly during setup and tuning.