Tamiya 49329 6mm End Cap - Body Height Kit  [49329]

Tamiya 49329 - 6mm AL End Cap
Price:
£8.02
Brand:
Tamiya
Model:
49329
Condition:
Brand New
Write a review

Adjust Shell Position with the Tamiya 49329 6mm Cap

The Tamiya 49329 6mm Aluminum End Cap is a compact part for adjusting body mount clearance on RC cars. It gives an additional 4mm so you can tweak the body height for better clearance or a cleaner stance.

Chassis Fit and Use Cases

The cap is compatible with Tamiya platforms such as TTG10R, TGR, TB-Evo I to III, and TRF414 and is intended for 6mm diameter body posts. It offers a quick fit solution to raise the body without altering the chassis geometry.

Fitting Advice for Reliable Results

Fit the Tamiya 49329 by pushing it onto the cut end of the existing body post and check that it seats evenly. A secure, aligned fit helps prevent shell movement and keeps the body at the chosen height during driving.

Will this work with polycarbonate shells?

Yes, it works well with polycarbonate bodies by lifting the shell slightly to reduce rubbing and to fine tune visual ride height.

Can I stack multiple end caps for more lift?

Stacking is not recommended as it may compromise fit and stability; use purpose made spacers if you need more than the 4mm this cap provides.

Should I check the mount after crashes?

Yes, inspect the cap and body mount after impacts to ensure they remain secure and have not deformed, which could affect body alignment.

Does fitting affect body centre of gravity?

A small change in body height has minimal effect on centre of gravity, but if you are tuning handling precisely, record changes and test the car to see any handling differences.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved