Tamiya 50886 - TB-01 Precision Aluminium Propeller Shaft Upgrade  [50886]

Tamiya 50886 - RC TB-01 Aluminum Propeller SP-886
Price:
£15.38
Brand:
Tamiya
Model:
50886
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Precision Propeller Shaft Upgrade for TB-01 Chassis

The Tamiya 50886 - TB-01 Aluminum Propeller Shaft is intended to tighten the drivetrain feel of TB-01 cars. By using aluminium to reduce rotating mass, it delivers crisper throttle response and improved acceleration without major chassis changes.

Installation and Compatibility Notes

Manufactured for TB-01 use, the propeller shaft is not a direct gear match for TB Evolution units because the supplied bevel gears are incompatible. To maintain correct gear engagement use the TB Evolution original bevel gear or the Tamiya 50911 TB Evolution Bevel Pinion Gear when pairing with Evolution components.

Will this work with strengthened drives?

It will work alongside many strengthened parts, but always check spline compatibility and shaft length. Reinforced components can alter load paths, so verify contact patterns after fitting.

How much acceleration improvement should I expect?

Exact gains vary with setup, but lowering rotating mass typically yields quicker throttle response and better initial acceleration, especially on tighter circuits.

Are special gear parts required for TB Evolution cars?

Yes, the bevel gears supplied with this part do not suit TB Evolution models. Use the TB Evolution original bevel gear or the Tamiya 50911 TB Evolution Bevel Pinion Gear for proper fitment.

What maintenance should I perform after fitting?

Check for endplay and wear at regular intervals, keep gears clean and lightly lubricated, and inspect spline engagement to prevent premature wear.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved