Tamiya 51461 TA06 Main & Middle Shaft Service Replacement  [51461]

Tamiya 51461 - TA06 Main & Middle Shaft SP-1461
Price:
£4.11
Brand:
Tamiya
Model:
51461
GTIN:
4950344514618
Condition:
Brand New
Write a review

Service the TA-06 drivetrain with the Tamiya 51461 TA06 shaft

The Tamiya 51461 TA06 Main & Middle Shaft is supplied for enthusiasts maintaining TA-06 chassis where drivetrain consistency is needed. It restores correct power flow and reduces uneven wear on downstream components.

Accurate fit for predictable performance

These shafts are produced to TA-06 specification so they seat correctly and maintain driveline geometry. Properly installed shafts help ensure repeatable handling and consistent response during diverse running conditions.

Best practice for installation

Remove any dirt from mating parts and inspect gear teeth before fitting the Tamiya 51461 TA06 shafts. Take care with alignment and gear mesh settings, and retest after a short run to confirm everything is operating as expected.

Can these shafts be used in tuned TA-06 builds?

Yes, they can be used in tuned cars but check that custom parts do not alter bearing positions or shaft clearances. Minor adjustments may be required for some custom setups.

How do I avoid premature wear?

Keep the drivetrain clean, use appropriate lubricants, and correct any misalignment that could cause side loads on the shaft ends.

Is a gear mesh change needed with this shaft?

Gear mesh should be checked and set after installation, as even correct shafts can alter mesh when replacing worn components.

What signs indicate a bent shaft?

Vibration under throttle, uneven rotation, or rapid wear on one side of a gear are common signs. Replace the shaft if any of these appear.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved