Tamiya 54005 Nitrage 5.2 OP-1005 Aluminium Rear Shock Tower Competition Upgrade  [54005]

Tamiya 54005 - Nitrage 5.2 Precision Aluminum Rear Shock Tower OP-1005
Price:
£26.30
Brand:
Tamiya
Model:
54005
Condition:
Brand New
Write a review

Rear Shock Tower Upgrade for Tamiya 54005 Nitrage 5.2

The Tamiya 54005 - Nitrage 5.2 Precision Aluminum Rear Shock Tower replaces the standard component with a 5mm aluminium unit to improve rear stability and mounting versatility. The design provides additional attachment points so upper arms and dampers remain well located under heavy loads.

Handling Improvements for Track Use

This tower gives builders more options to tune shock angles and roll centre, allowing incremental handling changes that suit hardpack or technical layouts. Better suspension location control helps maintain predictable responses at speed.

Compatibility Reminder

This part is compatible with the Tamiya Nitrage 5.2 only and does not fit the TNX 5.2R model. Check your model designation before ordering to avoid fit issues.

Is this tower suitable for club racing setups?

Yes, club racers use aluminium towers to reduce flex and keep setup consistent lap after lap, especially when fine tuning is required for specific tracks.

Will I need new shock mount hardware?

Often the existing hardware will work, but inspect the fit and replace any stripped or worn screws. Using thread locker on metal-to-metal joints can prevent loosening.

Can I tune roll centre with this tower?

Yes, the extra hole layout lets you adjust shock and arm mounting positions to alter roll centre and influence cornering balance.

Any tips for installation?

Keep original parts handy to compare positions, tighten fasteners evenly, and check alignment after first test run to confirm settings before racing.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved