Tamiya 95716 Super X Chassis Carbon Rear Roll Stay 1.5mm - Tamiya Jr HG  [95716]

Tamiya 95716 Jr HG carbon rear roll stay designed for Super X chassis

The Tamiya 95716 Jr HG Carbon Rear Roll Stay is a 1.5mm carbon fibre rear stay supplied as a replacement or service spare for Mini 4WD models that use the Super X chassis. It is identified as a spare-part item and is intended to match the Super X mounting layout.

Produced from a 1.5mm carbon sheet, this rear roll stay gives a rigid mounting face for rear rollers while keeping the overall build height low. The part suits enthusiasts wanting a direct-fit carbon stay for Jr HG sized fittings on Super X constructions, with a focus on material and fit rather than decorative finish.

Installation requires the usual Super X rear stay screws and spacer hardware; take care when tightening to avoid crushing the carbon laminate. Seasoned builders will recognise that 1.5mm carbon balances stiffness with modest flex; employ shims and washers as needed to protect the hole edges and manage plate-to-screw contact.

When replacing parts, inspect mounting holes for any delamination and confirm roller alignment relative to the rear bumper and plates. Lightly finish the carbon edges to remove splinters and avoid altering hole positions unless you intend to ream and reinforce them for alternate screw sizes.

A functional carbon rear roll stay for Super X chassis applications; suitable as a direct spare or to replace ageing plastic stays while retaining the original mounting pattern.