Tamiya BB-01 (BBX) Carbon Fibre Chassis Upgrade JR-TBBCK-CF by Jazrider  [JR-TBBCK-CF]

Tamiya BB-01 (BBX) Carbon Fiber Chassis Kit Set
Price:
£110.76
Brand:
JAZRIDER
Model:
JR-TBBCK-CF
Condition:
Brand New
Write a review
alt="Tamiya BB-01 (BBX) Carbon Fiber Chassis Kit Set" title="Tamiya BB-01 (BBX) Carbon Fiber Chassis Kit Set"
alt="Tamiya BB-01 (BBX) Carbon Fiber Chassis Kit Set" title="Tamiya BB-01 (BBX) Carbon Fiber Chassis Kit Set"

Carbon fibre chassis for BB-01 platform

This carbon fibre chassis kit is an aftermarket replacement for the Tamiya BB-01 (BBX) main plate, aimed at hobbyists wanting reduced flex and lower weight. The conversion influences chassis stiffness and mass distribution but does not change suspension geometry or gearbox positioning.

To install, remove the stock chassis plate and mount the carbon piece using the unit's original attachment points where possible. Perform careful clearance checks and ensure fasteners are torqued evenly to avoid creating stress points at the mounts. Basic RC hand tools are sufficient for the job.

Performance-wise expect crisper steering input and more consistent behaviour across laps. The plate is best used alongside methodical setup changes including damper tuning, tyre choice and ride-height adjustments to reach the preferred handling balance.

Specifications

  • Item: Tamiya BB-01 (BBX) Carbon Fiber Chassis Kit Set
  • Material: Carbon fiber
  • Model Number: JR-TBBCK-CF
  • Compatibility: Tamiya BB-01 (BBX) chassis series

A component-level chassis upgrade for BB-01 (BBX) models focused on stiffness and refined weight distribution to aid consistent handling and tuning precision.

Will this fit my BB-01 variant without trimming?

The plate is made for BB-01 (BBX) chassis series and should fit standard variants, but check your specific submodel and mounting layout before committing to final assembly.

Are electronic or motor positions affected?

No redesign of electronics mounting is implied; however verify battery, ESC and motor clearance once the plate is fitted to confirm there are no interference issues.

Do I need different mounting hardware?

Most builds can reuse the original hardware, but inspect screw lengths and spacer positions during trial assembly and replace any fasteners that do not seat correctly.

What should I check after first run?

After initial testing check for play or micro-cracks at mounting holes, confirm fastener torque, and reassess setup settings since chassis stiffness will change handling characteristics.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved