Tamiya CC-02 Aluminum Shock Tower Replacement Front & Rear JR-CC203-RD by Jazrider  [JR-CC203-RD]

Aftermarket aluminum shock tower for CC-02

This front and rear shock tower set is an aluminium replacement made for Tamiya CC-02 chassis layouts. Machined and red anodised, the towers replace plastic originals to give firmer shock attachment points and help maintain suspension geometry when using upgraded shock units.

The towers are intended for use when precise shock top location and repeatable mounting are required, such as during setup or when fitting higher-spec dampers. They serve a mechanical purpose: locating shock tops, altering leverage and roll traits, and delivering repeatable anchor points for suspension adjustments.

Fitting guidance: keep factory fasteners where appropriate, check alignment before final tightening, and confirm shock lengths and preload after installation to restore the correct ride height and travel. Sold as an accessory component; additional hardware is not included unless specified by the seller.