Tamiya CC-02 Rear Lower Link Arms - Precision Aluminum JR-CC210-RD by Jazrider  [JR-CC210-RD]

Rear Link Arm Function and Fit

This set of rear lower suspension link arms is intended for Tamiya CC-02 chassis applications and is listed under model JR-CC210-RD. The passage explains expected fitment, the installation approach, and the effect these arms have on suspension behavior for scale trail and crawler vehicles.

These aluminium links are a direct upgrade over stock plastic parts, reducing unwanted flex and helping to keep the axle aligned under load. As an upgrade they influence rear axle placement, roll center and anti-squat when matched with the CC-02's existing mount geometry. Make measured adjustments and note your baseline before altering multiple link settings to isolate changes in handling.

Fitting notes: the arms attach to the CC-02 rear mounting points using the usual hardware. Verify thread types and ball stud orientations to ensure correct installation and to avoid confusing front and rear lengths. After fitting, perform a static alignment and a brief low-speed run to confirm clearances around the axle and driveshafts.

Care and tuning advice: aluminium links resist bending but can shift impact forces to nearby plastic pivots and mounts; inspect these areas after initial runs. Tweak link lengths and angles in small increments and combine with damper and ride-height adjustments to fine tune handling balance.