TAMIYA CW-01 Precision Aluminum Motor Mount JR-LB06-LB by Jazrider  [JR-LB06-LB]

Tamiya CW-01 Chassis Aluminum Motor Mount
Price:
£4.83
Brand:
JAZRIDER
Model:
JR-LB06-LB
Condition:
Brand New
Available in shop
Write a review

Precision mount for reliable CW-01 drivetrain setup

This precision aluminum motor mount fits the Tamiya CW-01 chassis and is identified as model JR-LB06-LB. It replaces the original plastic bracket with a machined aluminium part that secures the motor in the intended position within the CW-01 drivetrain architecture.

The main benefit is improved repeatability: the mount keeps motor alignment steady so pinion-and-spur engagement stays consistent, reducing the chance of mesh-related wear or binding while tuning. After installation, trim and verify motor placement to achieve optimal gear clearance and quiet running.

Installation follows the same footprint as the stock mount on CW-01 compatible frames — remove the existing mount and refit the motor into the new aluminium bracket using the supplied or original screws. This is a tuning and maintenance accessory intended to assist with alignment rather than a performance power upgrade.

Can I use this on modified CW-01 layouts?

If the modified layout retains the CW-01 motor footprint the mount should fit, but check clearances around the gearbox and any body or chassis mods before final assembly.

How precise must mesh be with this mount installed?

Because the bracket holds the motor more rigidly, small mesh errors are less likely to self-correct; aim for an even, minimal clearance to avoid noise and reduce wear.

Does this change routine setup workflows?

The mount streamlines alignment checks by offering a stable reference point, but you should still follow standard mesh and hardware-tightening procedures during setup and after running.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved