Tamiya DF01 Rear Suspension Arms for Top Force / Manta Ray - JR-DF102-LB by Jazrider  [JR-DF102-LB]

Tamiya DF01 Top Force/ Manta Ray Aluminum Rear Suspension Arms (Blue)
Price:
£10.03
Brand:
JAZRIDER
Model:
JR-DF102-LB
Condition:
Brand New
Available in shop
Write a review

Aftermarket aluminum rear arms for DF01 chassis

These aluminum rear suspension arms are a direct-fit accessory intended for Tamiya DF01 1/10 buggies. The precision-machined aluminium and blue anodised finish provide a sturdier mounting surface than stock plastic arms, helping to control rear-end flex during aggressive driving and jumps.

Installation replaces OEM DF01 rear arms; fit using existing mounting pins and screws where they match, verify hinge-pin alignment, and confirm clearance with driveshafts and shock mounts. These components are supplied as a tuning option to alter rear compliance without immediately changing springs or dampers.

Note: Compatibility is restricted to the DF01 family and the models listed below; these arms must not be used on Tamiya RC Cayenna (58406) or Racing Lancer (58421).

Compatible Models

  • Tamiya 1/10 RC Buggy Top Force
  • Top Force Evolution
  • Manta Ray
  • Terra Conqueror
  • Blazing Star
  • Dirt Thrasher
  • DF01 Chassis

Which DF01 models are these arms intended for?

They are intended for DF01-series vehicles listed above, including Top Force, Top Force Evolution, and Manta Ray, and are designed around DF01 mounting geometry.

Will Top Force Evolution use the same hardware?

Top Force Evolution shares DF01-derived mounting points in the listed configurations, but you should confirm that your existing hinge pins and screws match before final assembly.

Any special checks before running the car?

After fitting, check hinge-pin alignment, ensure there is no interference with driveshafts or shocks, and perform a cautious test run to verify handling and clearance.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved