Tamiya DF-02 Front End Knuckle Arm DF2021 Aluminium by GPM  [DF2021]

Tamiya DF-02 Alloy Front Knuckle Arm - 1pr - GPM DF2021
Price:
£17.77
Brand:
GPM
Model:
DF2021
GTIN:
4894538039092
Condition:
Brand New
Write a review

Precision front knuckle for DF-02

This aluminium front knuckle arm is a replacement component for the Tamiya DF-02 chassis, intended to increase the strength of steering linkages while maintaining scale-friendly mass distribution.

The arm connects to standard DF-02 steering assemblies and ball ends, providing mounting for the servo linkage and steering pins. After fitting, check steering travel, toe and overall alignment to confirm correct setup.

Fitting guidance: remove the wheel and hub where needed on the DF-02, move any bearings or pins over from the original arm if applicable, and tighten using the original hardware torque recommendations. Verify free articulation through the suspension travel to prevent interference with brake or drive parts.

Specifications

  • Item: Front knuckle arm
  • Material: Aluminium alloy
  • Model Number: DF2021
  • Compatibility: Tamiya DF-02

Fit this aluminium knuckle to replace damaged plastic units or to provide a firmer steering pivot for DF-02 tuning; always re-check linkage geometry after installation for best handling.

Does this replace the OEM plastic knuckle directly?

Yes, it is designed for direct replacement on DF-02 steering assemblies; ensure original hardware is used and clearance is checked.

What benefits does aluminium give?

Aluminium increases rigidity at the steering pivot, improving precision and reducing flex compared with plastic knuckles.

Will I need to re-tune my setup?

Minor toe and steering trims are often needed after installing a stiffer knuckle to restore the original handling balance.

How do I keep the part serviceable?

Regularly check fastener torque, keep pivot areas clean, and replace worn bearings or pins to maintain smooth steering operation.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved