TAMIYA DT-03 58mm Aluminium Dogbone DT3158 by GPM  [DT3158]

Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158
Price:
£8.80
Brand:
GPM
Model:
DT3158
GTIN:
4894538052800
Condition:
Brand New
Write a review
alt="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158" title="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158"
alt="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158" title="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158"
alt="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158" title="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158"
alt="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158" title="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158"
alt="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158" title="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158"
alt="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158" title="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158"
alt="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158" title="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158"

Machined 58mm Dogbone for the DT-03

This machined aluminium 58mm dogbone is supplied as a 1pr set and serves as a drivetrain replacement for the TAMIYA DT-03 chassis in 1/10-scale RC models. It is intended to replace the factory plastic dog bones with a metal alternative while remaining for model use only.

Installation follows established DT-03 procedures: remove wheel hubs and driveshaft retainers, withdraw the original component, fit the 58mm aluminium dogbone into the outdrive cups and hubs, then reassemble and check axial play. The part matches DT-03 coupling geometry so verify clip seating and orientation before first run.

In practical tuning terms, aluminium dogbones change drivetrain feedback and wear characteristics compared with plastic; include routine inspections of joint ends and keep mating cups clean with light lubrication where necessary.

Does this suit all DT-03 cars?

The part is designed for TAMIYA DT-03 vehicles that use the standard 58mm dog bone and matching coupling geometry. Verify your car's specification before fitting.

Will it fit without modification?

In most DT-03 setups it is a direct fit, but confirm hub bore and retention clip condition to avoid binding or loss of retention.

Any tips for longevity?

Keep abrasive debris out of the cups, inspect ends for wear regularly, and use a light lubricant on contact points to extend service life.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved