Tamiya DT-03 Compatible Front Upright (Aluminium) - JR-DT306-RD by Jazrider  [JR-DT306-RD]

Tamiya DT-03 Aluminum Front Upright (Red)
Price:
£6.56
Brand:
JAZRIDER
Model:
JR-DT306-RD
Condition:
Brand New
Available in shop
Write a review

Front Upright for DT-03 Chassis

This aluminium front upright is produced as a replacement part for the Tamiya DT-03 platform and carries model reference JR-DT306-RD. It is intended to replace the standard plastic upright to deliver steadier steering geometry and improved mechanical feel.

Installation uses the standard DT-03 suspension mounting points and requires only basic RC tools; no bespoke adapters are necessary. When fitting, verify ball studs and bearing condition to preserve fluid steering movement.

From a setup viewpoint, aluminium uprights reduce flex at the front end, aiding in preserving toe and camber under load and offering a more consistent turn-in. The component is suitable for those refining handling characteristics without changing core suspension layout.

Will this change the car's corner entry behaviour?

Expect a firmer, more predictable entry due to reduced front flex; you may need to dial in small steering or toe adjustments to match your preferred balance.

Is this compatible with aftermarket ball studs and bearings?

Yes. The upright uses standard DT-03 mounting dimensions and works with common aftermarket ball studs and bearing sizes designed for that chassis.

What checks should I perform after fitting JR-DT306-RD?

After installation, check steering range, toe and camber settings, and torque on mounting screws. A short test run followed by a re-tighten is recommended to confirm stability.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved