Tamiya DT-03 Rear Hub Carrier, Aluminium Orange JR-DT307-OR by Jazrider [JR-DT307-OR]

Tamiya DT-03 Aluminum Rear Hub Carrier (Orange)

Price:

£7.95

Brand:

JAZRIDER

Model:

JR-DT307-OR

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

DT-03 hub carrier features

This machined aluminium rear hub carrier is designed specifically for the Tamiya DT-03 platform as a direct replacement for the factory plastic carrier. The metal construction provides a stable mounting surface for the rear wheel hub while preserving DT-03 geometry and serviceability.

Fitting is straightforward for anyone accustomed to DT-03 servicing: remove the original carrier, transfer bearings and any required small parts, attach the replacement to the existing mounting points with the supplied or original hardware, and confirm suspension travel and wheel alignment. Standard hex drivers and axle tools are normally sufficient.

For tuning the part delivers a stable mounting base for rear suspension and steering linkages, helping to keep alignment consistent under load and offering a repeatable pivot for setup changes. The orange anodised finish also aids quick inspection during maintenance cycles.

Will this carrier fit non-DT-03 chassis without modification?

The carrier is engineered for the Tamiya DT-03 chassis and is intended as a direct replacement on that platform; fitting to other chassis would likely require modification and is not supported by the original specification.

Any tips for ensuring correct alignment after installation?

After installing the carrier, transfer bearings and hardware, then run the wheels through their full travel to confirm there is no binding and adjust wheel alignment and fastener torque as needed for safe operation.