3RACING BS-FF03/V1 Bearing Set for Tamiya FF-03 Chassis  [BS-FF03/V1]

Tamiya FF-03 Ball Bearing Set - 3RACING BS-FF03/V1
Price:
£10.16
Brand:
3Racing
Model:
BS-FF03/V1
Condition:
Brand New
Write a review

Upgrade bearings for the Tamiya FF-03

The 3RACING BS-FF03/V1 ball bearing set provides a direct replacement for the standard bushings on the Tamiya FF-03 chassis. By lowering friction in the drivetrain the kit helps the car run more freely and reduces premature wear on moving parts.

Handling and speed improvements

Fitting ball bearings cuts resistance at rotating points, which can tighten up steering response and give a small improvement in rolling speed. These effects are most obvious on fast, even surfaces and during repeated timed laps.

Installation checklist

Prepare the right tools, press each bearing squarely into place and rotate to check for smoothness before final assembly. Proper seating of the 3RACING BS-FF03/V1 bearings ensures the best balance of durability and performance for the FF-03.

Will this set change my gear mesh or require gearbox changes?

No gearbox changes are normally needed. Bearings sit where the bushings were and do not alter gear spacing, but always check mesh after reassembly.

Can bearings tolerate offroad or dirt use?

Sealed bearings offer better protection, but heavy dirt and mud will still shorten service life. For dirty conditions expect more frequent cleaning or replacement.

How often should I inspect the bearings?

Check bearings periodically for smooth spin and side play, especially after long runs or wet conditions. Early inspection prevents damage to surrounding parts.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved