Tamiya FF-03 Graphite Servo Guard FF03-21/WO by 3Racing  [FF03-21/WO]

Servo protection plate for FF-03

This graphite servo protector suits the Tamiya FF-03 chassis family and is listed as part FF03-21/WO. It provides a lightweight, rigid shield for the servo mounting area and gives a local increase in chassis stiffness without changing suspension geometry.

As an aftermarket hop-up for 1/10 electric touring cars, compatibility is restricted to FF-03 layout designs and it should be considered a reinforcement rather than a main structural panel.

Fitting is done by placing the protector over the servo pocket and fastening to the existing mounting points on the FF-03 chassis using the stock fixings or common hex drivers. Always check servo lead and receiver clearance before fully tightening fasteners.

In practice the protector helps prevent direct impacts to servo cases during small crashes and can reduce flex around the servo bay, which may improve consistency in steering response when paired with sway bar, damping and servo saver adjustments. Confirm dimensions against your servo to ensure proper fit.