TAMIYA Front Uprights WR02/DT03T Light Blue Aluminum - JR-WR201-LB by Jazrider  [JR-WR201-LB]

Tamiya WR02/DT03T/Blitzer Beetle Aluminum Front Upright Set (Light Blue)
Price:
£6.84
Brand:
JAZRIDER
Model:
JR-WR201-LB
Condition:
Brand New
Available in shop
Write a review

Precision aluminum uprights for WR02/DT03T

This kit supplies aluminum front uprights for TAMIYA WR02, DT03T and Blitzer Beetle chassis. The light blue anodized finish marks the upgrade without changing the stock mounting footprint, and components are matched for left and right sides.

The uprights give a less compliant steering pivot than plastic, aiding retention of toe and camber during load events and improving repeatability across setup sessions. They provide a stable anchor for steering links and other front suspension parts.

Compatibility check: uprights are sized to the original front assembly mounting points on WR02/DT03T/Blitzer Beetle. Fit using the existing hardware where possible, then verify steering and suspension move freely through their full ranges to ensure no clearance issues.

Are these uprights exactly the same mounting pattern as the Tamiya originals?

They are produced to match the factory mounting pattern for WR02, DT03T and Blitzer Beetle front assemblies, intended as a direct replacement. Still, perform a dry fit to confirm there are no unexpected variances.

Will switching to metal uprights affect wheel alignment settings?

The uprights maintain mounting geometry, but because they reduce pivot flex you may notice alignment holds better and require only minor trim to return to your preferred settings.

What should I inspect after fitting these uprights?

Check steering link freedom, confirm no binding at full suspension droop and compression, and ensure pins and bearings seat correctly to avoid premature wear.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved