Tamiya Hornet EVO Compatible Front Lower Arms, Aluminium Upgrade - JR-THNE01-BK by Jazrider  [JR-THNE01-BK]

Tamiya Hornet EVO. (58742) Aluminum Front Lower Arms (Black)
Price:
£10.28
Brand:
JAZRIDER
Model:
JR-THNE01-BK
Condition:
Brand New
Available in shop
Write a review

Hornet EVO front arm particulars

The JR-THNE01-BK is an aluminium replacement front lower arm intended for Tamiya Hornet EVO chassis in RC buggy applications. It replaces the standard plastic lower arms while retaining the original geometry to allow direct installation.

Functionally the arm increases structural stiffness in the lower suspension link, which may change steering feel and how loads are carried through the front end. Supplied in black, it is intended as an aftermarket spare or tuning component for repairs and setup tweaks.

Installation follows the factory procedure: remove the wheel and any required front inserts, exchange the lower arm while keeping existing pins and mounting hardware, then check suspension travel and steering alignment after reassembly. Because a stiffer arm changes front feedback, re-check toe and camber once fitted.

Does this match Hornet EVO mounting geometry?

Yes, the arm is produced to match Hornet EVO mounting points. Verify your vehicle's lower arm layout before purchase to ensure compatibility with your specific variant.

Will this require different pins or bearings?

Typically no. The design is for reuse of the vehicle's existing pins and hardware, but inspect components for wear and replace as necessary during installation.

What checks should I do after fitting aluminium arms?

After fitting, confirm steering alignment, suspension travel and that fasteners are secure. Monitor mounting holes over time for signs of wear and address any looseness promptly.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved