This rear drive shaft and wheel axle set is compatible with TAMIYA Hotshot chassis variants and is designed to restore rear drivetrain operation after wear or impact, while enabling straightforward adjustments to rear-end geometry on vintage Hotshot layouts.
Fitting is performed at the rear gearbox and wheel hub junctions, utilising the stock mounting points on Hotshot models. The typical procedure involves removing the rear hub assembly and axle carrier to access the drive shaft, replacing the unit, and reassembling with the original hardware. No custom fabrication is required when used with the listed Hotshot variants.
Tuning advice: as a direct-replacement component this kit assists with axle alignment and endplay settings. After installation check axle engagement, hub clearance and the mesh between motor, spur and pinion to ensure everything operates within chassis tolerances.
Copyright © 2008-2026 rcjaz.co.uk All rights reserved
