Tamiya M03 Family 2 Degree Rear Hub Carrier Aluminium M04M-03/2/LB by 3Racing  [M04M-03/2/LB]

Price:
£8.43
Brand:
3Racing
Model:
M04M-03/2/LB
Condition:
Brand New
Write a review

Precision aluminium rear hub for Tamiya M03 chassis

This rear hub carrier from 3Racing is engineered for Tamiya M03, M03L, M04M and M06 PRO chassis and provides a 2 degree option to adjust rear geometry. It is designed as a direct replacement for the OEM carrier while maintaining the original mounting interfaces so other suspension components remain unchanged.

Material choice and surface treatment prioritise consistent performance and longevity. The light blue anodised aluminium increases stiffness compared with plastic carriers and preserves factory attachment points for a clean swap. The fixed 2 degree angle allows precise, incremental changes to rear handling.

Fitting notes: check that this carrier suits your chassis variant, remove the original hub carrier and reinstall using the vehicle's hardware where applicable, verify clearance at the rear upright and wheel hex before final torque, and recheck wheel alignment after running.

Supported models

  • Tamiya M03
  • Tamiya M03L
  • Tamiya M04M
  • Tamiya M06 PRO

Will fitting this affect tyre clearance?

Most installations do not change tyre clearance, but always spin the wheel and check for contact with the upright or hex before finalising hardware torque.

Is this suitable for competitive setups?

Yes, the 2 degree aluminium carrier is intended as a tuning option for drivers wanting to refine rear behaviour in club or competitive settings.

Any special checks after first run?

After the first session, check fasteners, confirm alignment and inspect the carrier and surrounding parts for signs of interference or unexpected wear.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved