Tamiya M03/M03L/M04M/M06 PRO 1 degree Rear Hub Carrier Light Blue M04M-03/1/LB by 3Racing  [M04M-03/1/LB]

Price:
£8.28
Brand:
3Racing
Model:
M04M-03/1/LB
Condition:
Brand New
Write a review

Rear hub carrier for Tamiya PRO chassis - 1 degree

An aluminium rear hub carrier set to one degree, finished in light blue anodise, intended for Tamiya M03, M03L, M04M and M06 PRO touring chassis. It replaces the standard carrier to enable fine rear geometry adjustments on road and touring cars.

The component adds a one degree offset to the rear hub mounting angle versus the factory part, offering a modest and repeatable tuning step. Use it to fine-tune rear alignment when experimenting with setup options without swapping major suspension pieces.

To install, remove the original rear hub carrier and reassemble the rear upright and driveline items in the same orientation; inspect fit and clearance and recheck wheel alignment before driving. This is for RC model use only.

Will this fit both M03 and M04M uprights?

Yes, it is designed for the Tamiya M03, M03L, M04M and M06 PRO uprights, but always check for any local variant differences.

Should I replace bearings when fitting this carrier?

The description does not state that bearings are included; consider fitting fresh bearings if you want optimal running and minimal play.

How to verify the change after installation?

After installing, inspect hub and tyre clearance, confirm driveline alignment and perform a short drive to evaluate handling and stability changes.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved