TAMIYA M05 Factory-Form Ball Bearings BS-M05ORG/V1  [BS-M05ORG/V1]

Tamiya M05 Ball Bearing Set (Original) - 3RACING BS-M05ORG/V1
Price:
£9.98
Brand:
3Racing
Model:
BS-M05ORG/V1
Condition:
Brand New
Write a review

Factory-form bearings for M05

This original-form ball bearing set is intended as a direct substitute for worn bearings on the TAMIYA M05 electric touring chassis, preserving the factory specification and fitment.

Fitting ball bearings in place of bushes lowers rotational drag and simplifies routine maintenance. Install in steering joints, wheel hubs and gearbox outputs where the stock bearing dimensions are specified, taking care to remove debris from housings prior to seating the bearings.

Fitting guidance: use a matching driver or gentle press to insert bearings without stressing the inner race, check for any axial play after installation, and reassemble gears to their original mesh. Proper bearings reduce concealed drag so suspension and motor tuning changes are easier to assess.

Are these a like-for-like replacement?

Yes, the set is produced to match the original bearing form and fit used on the M05, suitable for replacing worn units.

What is the best way to seat the bearings?

A proper bearing driver or a soft-faced press will seat bearings evenly; avoid hammering the inner race and work on a clean bench to keep out contaminants.

Will switching to bearings change gearing needs?

Bearings reduce drivetrain drag, which can slightly alter effective gearing feel; check acceleration and motor temperature after fitting to confirm your setup.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved