Tamiya M-05/M-06/MF-01X Rear Suspension Arms - Aluminium Upgrade JR-M502-LB by Jazrider  [JR-M502-LB]

Tamiya M05/M06/MF-01X Aluminum Rear Suspension Arms (Light Blue)
Price:
£7.36
Brand:
JAZRIDER
Model:
JR-M502-LB
Condition:
Brand New
Available in shop
Write a review

Rear arm compatibility and tuning notes

The JR-M502-LB aluminium rear arm is designed specifically for the Tamiya M-05, M-06 and MF-01X chassis and is offered as a direct replacement where mount geometry matches. It aims to reduce flex and improve part longevity compared with typical plastic rear arms.

Compatibility is restricted to the models listed; confirm your chassis code before fitting. Installation follows the same mounting arrangement as the original arm: remove the old piece, inspect pivot and hinge-pin fit, then refit with the original hardware. After installation recheck rear toe and camber to ensure handling remains within your desired parameters.

As a tuning component this aluminium arm changes rear response by limiting flex rather than modifying suspension geometry. The light blue finish is decorative and has no impact on mounting accuracy.

Which specific chassis codes are supported by JR-M502-LB?

Only Tamiya M-05, M-06 and MF-01X variants that use the same rear arm mounting layout are supported. Verify the mount points on your chassis before purchasing.

Will fitting these arms require a change to my shock or link lengths?

No. Since the arm preserves stock mount geometry, shock and link lengths remain unchanged. Tune shock damping or spring rates if you want to adjust how the reduced flex translates to handling.

Are there special care notes for the aluminium surface?

Clean the arm periodically and inspect mounting faces for wear. The light blue finish is decorative; if scratched, corrosion is unlikely but remove debris to prevent abrasion at pivot points.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved