Tamiya MF01X CVD Drive Shaft Set Front/Rear MF1230C by GPM  [MF1230C]

Replacement CVD Shafts in Hard Steel

This aftermarket shaft set is made for Tamiya MF01X chassis and is referenced as model MF1230C. It includes front and rear constant velocity drive shafts in hard steel for scale RC vehicles, intended to replace worn original parts when a metal driveline component is preferred.

As a direct replacement for CVD setups on MF01X cars, the hard steel parts are specified to offer enhanced wear resistance versus softer materials. The set is suitable for repairing broken shafts, removing driveline play, or preparing a car for heavier duty running.

Installation guidance: confirm MF01X CVD fitment before fitting, inspect retaining clips, pins and bearings, and check spline engagement and pin retention during assembly. After replacement, recheck suspension droop and toe to retain the vehicle's intended handling characteristics.

Install this set when renewing MF01X CVD shafts to preserve driveline integrity and to use metal replacement parts during maintenance or setup work.