Tamiya MF01X Rear Knuckle Arm Upgrade MF022 by GPM  [MF022]

Tamiya MF01X Aluminium Rear Knuckle Arm - 1pr set - GPM MF022
Price:
£13.98
Brand:
GPM
Model:
MF022
GTIN:
4894538042047
Condition:
Brand New
Write a review

Precision aluminium rear knuckle for MF01X chassis

This aluminium rear knuckle arm is an aftermarket replacement for Tamiya MF01X models, supplied as a 1pr set to replace the original plastic knuckles. It is intended to provide a stronger mounting point for the rear hub on tuned cars and regular driving alike.

The metal knuckle changes the rear steering stiffness and can alter toe and camber response under load compared with stock parts. It is useful when you need a firmer pivot for suspension tuning and more repeatable setup measures after adjustments.

Install by removing the rear hub carriers and associated fasteners, transferring bearings or pins from the factory units, then fitting the aluminium knuckle with the original hardware and thread locker where advised. After installation, confirm suspension travel and wheel alignment before running the model.

Specifications

  • Item: Rear knuckle arm, 1pr set
  • Material: Aluminium
  • Model Number: MF022
  • Compatibility: Tamiya MF01X

Fit this aluminium knuckle to gain a more durable rear hub mount on MF01X cars and to support finer adjustments when dialling in handling.

Is this suitable for track and bashing?

Yes, the aluminium knuckle is more robust than stock plastic and suits both track tuning and general hobby use, though it may transfer more impact forces to adjoining components.

Will it affect gearing or drivetrain?

No direct change to gearing is expected, but the altered mass and stiffness at the rear can subtly change handling; check drivetrain alignment after fitting.

What torque should I use on fasteners?

Use firm but moderate torque to avoid stripping screws in plastic mounts. Use thread locker on metal-to-metal joints as needed and recheck after a few runs.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved