Tamiya M4WD-16 Mini 4WD Carbon Roller Flat Plate by 3RACING  [M4WD-16]

Tamiya Mini 4WD Carbon Multi Roller Flat Plate - 3RACING M4WD-16
Price:
£3.73
Brand:
3Racing
Model:
M4WD-16
GTIN:
4895124749791
Condition:
Brand New
Available in warehouse
Write a review

Race-oriented carbon flat plate for Mini 4WD

The Tamiya Mini 4WD Carbon Multi Roller Flat Plate by 3Racing is produced from strong carbon material to offer an effective balance of toughness and lightness. It is intended for hobbyists and racers who want consistent handling under load.

Compatibility notes

The plate installs on numerous Tamiya Mini 4WD chassis variants and supports multiple mounting configurations. Adjusting roller placement lets you tune the car for different track sections and obstacles.

Performance considerations

When used in a tuned setup, the plate can reduce unwanted side contact and stabilise corner entry, helping lap time consistency across changing track features.

Will this work with older Mini 4WD models?

It is compatible with many older models, though you should verify hole spacing and, if necessary, use short spacers or different screw lengths for a secure fit.

Does the plate need reinforcement?

Carbon is strong enough for typical racing loads; reinforcement is rarely needed unless you run very heavy accessories or aggressive impacts are common.

How does it affect maintenance?

Maintenance is straightforward: check mounting screws and roller bearings regularly and clean any grit that may build up around mounting points.

Can I pair this with aftermarket bumpers?

Yes, but ensure combined widths and mounting positions do not interfere; test clearances before final tightening to avoid rubbing in corners.

What setup changes produce the biggest gains?

Fine-tuning roller height and lateral spacing often yields the biggest handling improvements; small iterative changes followed by test laps work best.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved