TAMIYA Rear Hub Carrier - Anodised Red Aluminum for TL-01/GF-01/WR-02 TL01-13305-RD by Jazrider  [TL01-13305-RD]

High-strength rear hub carrier for TAMIYA TL-01 family

This anodised red aluminum rear hub carrier is supplied as a replacement for TAMIYA TL-01, GF-01 and WR-02 chassis variants. It provides the rear wheel mounting surface and anchors suspension link hardware on compatible TAMIYA frames. The text below highlights fit verification, installation procedure and maintenance tips.

Fit and role: The carrier locates the wheel hub and supplies mounting bosses for suspension links and axle fixings. Fitment is intended where the stock geometry and mounting points match the TL-01, GF-01 or WR-02 layouts. Always check hole patterns and bearing sizes on your chassis prior to fitting.

Installation notes: Remove the rear wheel and detach the original carrier following your chassis service instructions. Standard metric hex keys and small wrenches will typically handle the job, along with any wheel nut tools. Bearings and axle hardware are normally sourced from the chassis or donor parts; confirm with the seller whether any extra fasteners are included.

Tuning and maintenance: Upgrading to an aluminium carrier changes the stiffness at the attachment points; be cautious with screw torque to prevent thread damage in plastic bulkheads. When altering suspension geometry, proceed incrementally and verify toe and camber under static load. Check fasteners and bearings regularly.