TAMIYA Rear Upper Suspension Arms for Hotshot / Super Hotshot — Aluminum Red JR-THS05-RD by Jazrider  [JR-THS05-RD]

Tamiya Hotshot, Super Hotshot Aluminum Rear Upper Suspension Arms (Red)
Price:
£11.17
Brand:
JAZRIDER
Model:
JR-THS05-RD
Condition:
Brand New
Available in shop
Write a review

Replacement Rear Upper Arms for Hotshot Chassis

This aluminium rear upper suspension arm set is an aftermarket hop-up intended for Tamiya Hotshot and Super Hotshot models. The red finish and machined surfaces are produced to mirror the stock mounting points so they install as direct swaps where geometry matches.

The stiffer aluminium links help preserve suspension geometry under load, which supports a more consistent handling platform for fine tuning. Installation follows standard arm replacement steps and will often allow reuse of original mounting hardware. Always confirm full range suspension movement and clearance after fitting.

Specifications

  • Item: Rear upper suspension arms
  • Material: Aluminum
  • Model Number: JR-THS05-RD
  • Compatibility: Tamiya Hotshot, Super Hotshot

An aluminium upgrade aimed at drivers seeking reproducible suspension characteristics and improved chassis response during setup.

Will these arms fit any Hotshot-era variant?

They are designed for Hotshot and Super Hotshot configurations that retain the original rear upper arm mounting layout; verify your chassis matches the stock locations before purchase to ensure fitment.

Do I need special shims or spacers?

Most installations do not require additional shims if the chassis uses stock geometry, but if there is play or misalignment you may need thin shims to correct the spacing for optimal articulation.

Are adapters needed for different pivot pins?

If your model uses non-standard pivot hardware, adapters or different pins may be necessary. Inspect the arm bore and compare pin diameters before reassembly to avoid binding.

How do I confirm geometry after fitting?

Check ride height, camber, and that the suspension travels freely without rubbing. A brief setup session with incremental changes will confirm the arms are delivering the expected geometry consistency.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved